Removing And Installing Cylinder Head; Cylinder Head - Exploded View - Audi A8 2003 Workshop Manual

Audi A8 2003 ➤
8-cylinder TDI engine (4.2 ltr. 4-valve common rail), mechanics - Edition 12.2013
2 Removing and installing cylinder
head
⇒ "2.1 Cylinder head - exploded view", page 152
⇒ "2.2 Cylinder head cover - exploded view", page 154
⇒ "2.3 Removing and installing cylinder head cover", page 155
⇒ "2.4 Removing and installing cylinder head", page 156
⇒ "2.5 Checking compression", page 161
2.1

Cylinder head - exploded view

Note
Illustration shows right-side cylinder head.
1 - Cylinder head gasket
❑ Renewing
⇒ "2.4 Removing and in‐
stalling cylinder head",
page 156
❑ Installation position:
Part No. towards cylin‐
der head
❑ If renewed, change
coolant and engine oil
2 - Gasket
❑ Renew
3 - 9 Nm
4 - 23 Nm
5 - Rear engine lifting eye
6 - Bolt
❑ Tightening torque
⇒ Item 18 (page 251)
7 - O-ring
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
❑ Renew
with respect to the correctness of information in this document. Copyright by AUDI AG.
8 - Hall sender - G40-
9 - 9 Nm
10 - Banjo bolt, 12 Nm
11 - Seal
❑ Renew
12 - Coolant pipe
13 - Seal
❑ Renew
14 - Dowel sleeve
❑ For intake manifold
❑ 2x
15 - Cylinder head bolt
❑ Renew
152
Rep. gr.15 - Cylinder head, valve gear