Audi A8 2003 Workshop Manual page 189

8-cylinder TDI engine (4.2 ltr. 4-valve common rail), mechanics - Edition 12.2013
1
1 - 8 Nm + 90° ( / 4 turn) further
❑ Renew
❑ Tighten in stages and in
diagonal sequence
2 - Sump (bottom section)
❑ Removing and installing
⇒ page 184
❑ With oil level and oil
temperature sender -
G266-
❑ Removing and installing
oil level and oil temper‐
ature sender - G266-
⇒ page 184
3 - 9 Nm
4 - Retaining ring
5 - Intake connecting pipe
6 - Oil strainer
❑ Clean if dirty
7 - 9 Nm
8 - 9 Nm
9 - Oil pipe
10 - O-ring
❑ Renew
1
11 - 8 Nm + 90° ( / 4 turn) fur‐
ther
❑ Renew
12 - Seal
❑ Renew
13 - Suction duct
14 - Drive shaft
❑ For coolant pump
15 - Dowel sleeve
❑ 2x
16 - Gasket
❑ Renew
17 - Oil pump
❑ Do not dismantle
❑ With pressure control valve: 4.5 bar
❑ Removing and installing
18 - Drive shaft
❑ For oil pump
19 - 9 Nm
20 - Gasket
❑ Renew
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
⇒ page 195
1. Removing and installing parts of lubrication system
Audi A8 2003 ➤
183