10 - ATF strainer
❑
⇒ „1.2 Removing and installing ATF strainer", page 97
11 - O-ring
❑ Always renew
12 - Retaining clip for wiring harness connector
13 - Wiring harness in gearbox
❑
⇒ „1.5 Removing and installing wiring harness in gearbox", page 105
14 - Bolt
❑ Secures mechatronic unit to gearbox
❑ 8 Nm
Different numbers and versions of bolts depending on gearbox code letters:
Follow removal and installation instructions and select correct type from ⇒ Electronic parts catalogue
❑
⇒ „1.4 Removing and installing mechatronic unit - gearbox with 13 bolts on oil pan", page 102
❑
⇒ „1.3 Removing and installing mechatronic unit - gearbox with 24 bolts on oil pan", page 99
15 - Mechatronic unit
Various versions apply, depending on the gearbox code letters:
Follow removal and installation instructions and select correct type from ⇒ Electronic parts catalogue
❑
⇒ „1.4 Removing and installing mechatronic unit - gearbox with 13 bolts on oil pan", page 102
❑
⇒ „1.3 Removing and installing mechatronic unit - gearbox with 24 bolts on oil pan", page 99
16 - Seal
1.1
Removing and installing oil pan
Special tools and workshop equipment required
♦ Guide pins (4x) -T40199-
♦ Used oil collection and extraction unit -V.A.G 1782-
♦ Safety goggles
Note
Rules for cleanliness when working on the automatic gearbox
♦
⇒ page 11
General repair instructions
♦
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
⇒ page 1
.
Audi A6 2005 ➤ , Audi A8 2003 ➤
1. Oil pan, ATF strainer and mechatronic unit - exploded view
93