Audi A8 2003 Workshop Manual page 195

8-cylinder TDI engine (4.2 ltr. 4-valve common rail), mechanics - Edition 12.2013
– Unscrew rear bolts -3- for body brace.
– Attach adapters - 10 - 222 A /21- without cross beam onto
suspension turrets.
• Supports are marked for left and right side of vehicle.
• The centre resting point -2- of supports is positioned on front
bolts for body brace.
• The adapters - 10 - 222 A /21- are attached by means of the
rear securing bolts -3- for the body brace.
• The knurled screw -1- must be screwed down until support
plate rests on suspension turret.
– Fit cross beam with adapters - 10 - 222 A /3- to adapters - 10
- 222 A /21- .
– Attach shackles - 10 - 222 A /12- to engine lifting eyes.
– Secure spindles of support bracket - 10 - 222 A- to shackles -
10 - 222 A /12- .
– Take up weight of engine using spindles of support bracket.
– Remove both front wheels.
– Release fasteners -1- and remove front noise insulation.
– Remove front sections of front wheel housing liners (left and
right) ⇒ Rep. gr. 66 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1. Removing and installing parts of lubrication system
Audi A8 2003 ➤
189