8-cylinder TDI engine (4.2 ltr. 4-valve common rail), mechanics - Edition 12.2013
– Unplug electrical connector -2- at oil temperature sender -
G8- .
– Unscrew oil temperature sender - G8- .
Note
Disregard -item 1-.
Installing
Installation is carried out in the reverse order; note the following:
Note
Renew seal.
Tightening torque
Component
Oil temperature sender - G8- to oil line
1.15
Checking oil pressure
Special tools and workshop equipment required
♦ Oil pressure tester - V.A.G 1342-
Procedure
•
Oil level OK
•
Engine oil temperature approx. 80 °C
– Remove oil temperature sender - G8-
– Connect oil pressure tester - V.A.G 1342- to threaded hole for
oil temperature sender - G8- .
– Screw used oil pressure switch into threaded hole for oil pres‐
sure tester - V.A.G 1342- to seal hole.
– Start engine.
•
Minimum oil pressure at idling speed: 0.8 bar.
•
Oil pressure at 2000 rpm: at least 2.5 bar.
Assembling
Installation is carried out in the reverse order; note the following:
– Install oil temperature sender - G8-
Nm
14
⇒ page 210
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
⇒ page 210
.
1. Removing and installing parts of lubrication system
Audi A8 2003 ➤
211