Audi A8 2003 Workshop Manual page 91

8-cylinder TDI engine (4.2 ltr. 4-valve common rail), mechanics - Edition 12.2013
– Drive oil seal -2- into adapter -1- (use assembly tool -
T10053- ).
Remaining installation steps are carried out in reverse sequence;
note the following:
Note
Renew seals and O-rings.
– Install toothed belt for high-pressure pump ⇒ Rep. gr. 23 .
– Install subframe ⇒ Rep. gr. 40 .
– Tighten subframe bolts only to specified torque (do not turn
further). Do not tighten bolts to final setting until after wheel
alignment check has been performed ⇒ Rep. gr. 40 .
WARNING
The vehicle must not be driven at this stage.
– Install anti-roll bar ⇒ Rep. gr. 40 .
– Install front sections of front wheel housing liners (left and
right) ⇒ Rep. gr. 66 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A8 2003 ➤
3. Servicing work on timing chain end
85