Audi A8 2003 Workshop Manual page 21

8-cylinder TDI engine (4.2 ltr. 4-valve common rail), mechanics - Edition 12.2013
– Detach cable junction for bonnet lock cables -1- from lock car‐
rier.
– Open cable junction and detach both bonnet lock cables -2-.
– Move coolant line going to coolant expansion tank clear at lock
carrier.
– Remove bolts -1-, -3- and -5-.
– Remove bolt -4- and nut -6-.
– Slacken hose clip -2- and detach air pipe.
– Detach air duct from charge air cooler (left-side).
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
– Extract hydraulic fluid for power steering from reservoir using
with respect to the correctness of information in this document. Copyright by AUDI AG.
used oil collection and extraction unit .
– Place used oil collection and extraction unit underneath.
– Detach hydraulic lines for power steering -2-.
– Detach refrigerant lines -1- from condenser.
– Seal off open lines and connections with clean plugs from en‐
gine bung set - VAS 6122- .
– Remove bolts -1-, -3- and -5-.
– Remove bolt -2- and nut -6-.
– Slacken hose clip -4- and detach air pipe with hose.
– Detach air duct from charge air cooler (right-side).
Audi A8 2003 ➤
15
1. Removing engine