Audi A8 2003 ➤
8-cylinder TDI engine (4.2 ltr. 4-valve common rail), mechanics - Edition 12.2013
– Position support elements from -VAS 6131/10- at rear of gear‐
box, as shown in illustration.
– Turn all spindles for the support elements upwards until all lo‐
cating lugs make contact with the mounting points.
– When all support elements make contact, raise assembly plat‐
form until load is taken off engine and gearbox mountings.
– Tighten base plates for support elements on scissor-type as‐
sembly platform - VAS 6131 A- to 20 Nm.
– Remove bolts -arrows- at tunnel cross member.
– Mark the installation position of subframe with a felt-tip pen on
longitudinal member.
– Remove bolts -1- and -4-.
– Remove bolts -2- and -3- in a diagonal sequence and in
stages.
Note
Check that all hoses and wiring connections between engine,
♦
gearbox, subframe and body have been detached.
Carefully guide out engine/gearbox assembly with subframe
♦
from engine compartment when lowering to avoid damage.
– Lower engine/gearbox assembly gradually.
– Pull out scissor-type assembly platform - VAS 6131 A- from
under the vehicle.
30
Rep. gr.10 - Removing and installing engine
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.