Removing And Installing Spur Gear Drive - Audi A8 2003 Workshop Manual

Audi A8 2003 ➤
8-cylinder TDI engine (4.2 ltr. 4-valve common rail), mechanics - Edition 12.2013
– Drive oil seal for power steering pump drive in onto stop with
thrust piece -T40193- .
Remaining installation steps are carried out in reverse sequence;
note the following:
Note
Renew seals and O-rings.
♦
Secure all hose connections with the correct type of hose clips
♦
(same as original equipment) ⇒ Electronic parts catalogue .
– Install engine cross member and engine mounting
⇒ page 46 .
– Install power steering pump ⇒ Rep. gr. 48 .
– Install drive shaft (left-side) ⇒ Rep. gr. 40 .
– Install starter catalytic converter
– Fill up hydraulic fluid for power steering and bleed steering
system ⇒ Rep. gr. 48 .
– Install subframe ⇒ Rep. gr. 40 .
– Tighten subframe bolts only to specified torque (do not turn
further). Do not tighten bolts to final setting until after wheel
alignment check has been performed ⇒ Rep. gr. 40 .
WARNING
The vehicle must not be driven at this stage.
– Perform wheel alignment check ⇒ Rep. gr. 44 .
WARNING
Tighten bolts for subframe to final setting after performing
wheel alignment check.
1.12

Removing and installing spur gear drive

Special tools and workshop equipment required
♦ Used oil collection and extraction unit - V.A.G 1782- or -VAS
6622A-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
148
Rep. gr.15 - Cylinder head, valve gear
⇒ page 295 .