Audi A8 2003 Workshop Manual page 38

Audi A8 2003 ➤
8-cylinder TDI engine (4.2 ltr. 4-valve common rail), mechanics - Edition 12.2013
– Set up scissor-type assembly platform - VAS 6131 A- with
support set for Audi - VAS 6131/10- as follows:
Platform co‐ Parts from support set for Audi - VAS 6131/10-
ordinates
1) /10-1
C3
1) /10-1
G3
D7 /10-1
F7 /10-1
B11 /10-1
G11 /10-1
/10-1
1)
D16
1) /10-1
G15
• 1)
Support elements remain unchanged.
• 2)
Two washers (total height: 3 mm) must also be placed on
the support element.
– Remove bolt -2- on engine/gearbox flange (bottom left).
– Place two washers -1- (total height: 3 mm) on locating lug for
support element at rear left of engine.
– Position support elements from -VAS 6131/10- at rear left of
sump (top section), as shown in illustration.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Position support elements from -VAS 6131/10- at left of en‐
gine/gearbox assembly, as shown in illustration.
– Position support elements from -VAS 6131/10- at right of en‐
gine/gearbox assembly, as shown in illustration.
– Turn spindles for the support elements upwards until all locat‐
ing lugs make contact with the mounting points.
– Tighten base plates for support elements on scissor-type as‐
sembly platform - VAS 6131 A- to 20 Nm.
32
Rep. gr.10 - Removing and installing engine
/10-4 /10-5
/10-4 /10-5
/10-4 /10-5
/10-11
/10-4 /10-5
/10-4 /10-5
/10-3 /10-5
/10-4 /10-5
/10-4 /10-5
/10-6
/10-6
2)
/10-11
/10-12
/10-13
/10-9
/10-10