Audi A8 2003 Workshop Manual page 284

Audi A8 2003 ➤
8-cylinder TDI engine (4.2 ltr. 4-valve common rail), mechanics - Edition 12.2013
Fitting locations of components on particulate filter (right-side)
2 - Pressure pipe to pressure differential sender - G505-
♦ Coat thread with high-temperature paste; for high-tem‐
perature paste refer to ⇒ Electronic parts catalogue
♦ Tighten union nut to 40 Nm
3 - Temperature sender before particulate filter - G506-
♦ Removing and installing
4 - Pressure pipe to pressure differential sender - G505-
♦ Coat thread with high-temperature paste; for high-tem‐
perature paste refer to ⇒ Electronic parts catalogue
♦ Tighten union nut to 40 Nm
Note
Disregard -item 1-.
Fitting locations on rear of gearbox
1 - Electrical connector for temperature sender 2 before par‐
ticulate filter - G498-
2 - Pressure differential sender - G505-
♦ Removing and installing ⇒ Rep. gr. 23
3 - Electrical connector for temperature sender before partic‐
ulate filter - G506-
4 - Pressure differential sender 2 - G524-
♦ Removing and installing ⇒ Rep. gr. 23
Fitting locations of components on starter catalytic converter (left-
side)
1 - Lambda probe 2 - G108-
♦ Removing and installing ⇒ Rep. gr. 23
278
Rep. gr.26 - Exhaust system
⇒ page 291
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.