Removing And Installing Coolant Pump - Audi A8 2003 Workshop Manual

Audi A8 2003 ➤
8-cylinder TDI engine (4.2 ltr. 4-valve common rail), mechanics - Edition 12.2013
1.4

Removing and installing coolant pump

Special tools and workshop equipment required
♦ Drip tray for workshop hoist - VAS 6208-
Removing
Note
All cable ties which are released or cut open when removing must
be fitted in the same position when installing.
– Remove radiator ⇒ page 242
– Remove radiator cowl
– Remove coolant pipes (front)
– Unplug electrical connector -2- going to charge pressure send‐
er - G31- .
Note
Disregard -item 1-.
– Remove bolts -arrows- and detach bracket for charge air cool‐
er.
– Take off charge air cooler -1- (left-side).
Note
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
Disregard -item 2-.
with respect to the correctness of information in this document. Copyright by AUDI AG.
222
Rep. gr.19 - Cooling
.
⇒ page 246 .
⇒ page 227 .