Removing And Installing Radiator - Audi A8 2003 Workshop Manual

Audi A8 2003 ➤
8-cylinder TDI engine (4.2 ltr. 4-valve common rail), mechanics - Edition 12.2013
Connecting coolant hose with plug-in connector
– Remove old O-ring -2- from coolant hose -3-.
– Lubricate new O-ring with coolant additive and fit O-ring in
coolant hose.
– Press coolant hose onto connection -1- until it engages audi‐
bly.
– Press coolant hose in again and then pull to check that plug-
in connector is correctly engaged.
1.13

Removing and installing radiator

Special tools and workshop equipment required
♦ Drip tray for workshop hoist - VAS 6208-
♦ Hose clip pliers - VAS 6362-
Removing
– Carefully pull engine cover panel off four retaining pins one
after the other -arrows-.
242
Rep. gr.19 - Cooling
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.