Suzuki 2006 SX4 Service Manual page 685

4) Using special tool and hydraulic press (1), compress
2nd coast brake piston return spring (2) until spring
seat is pushed down to 1 – 2 mm (0.039 – 0.078 in.)
lower than snap ring groove and remove snap ring
(3).
Special tool
(A): 09926–98350
CAUTION
!
Be careful when applying pressure, for
overpressure will cause plate section of 2nd
coast brake piston return spring to deform.
5) Remove 2nd coast brake piston return spring (2).
2
3
6) Remove 2nd coast brake piston (1) with O-rings by
applying compressed air (400 – 800 kPa, 4 – 8 kg/
cm 2 , 57 – 113 psi) from through oil hole (2).
NOTE
If piston does not pop out, it is recommended
to use needle-nose pliers for removal.
2
7) Remove snap ring (1), using flat end rod or the like.
8) Remove retaining plate, friction plates, separator
9) Remove 2nd brake piston return spring (2).
1
10) Remove 2nd brake piston (1) with O-rings applying
(A)
I4RH01510092-01
11) Remove stator shaft (1) by removing 14 bolts (2).
1
I4RH01510093-01
Automatic Transmission/Transaxle:
plates and cushion plate.
compressed air (400 – 800 kPa, 4 – 8 kg/cm
113 psi) from through oil hole (2).
NOTE
If piston does not pop out, it is recommended
to use needle-nose pliers for removal.
2, (b)
2, (a)
2, (b)
5A-97
2
1
I4RH01510094-01
2 , 57 –
1
2
I4RH01510095-01
2, (b)
1
2, (b)
I4RH01510096-01