Front Strut Assembly Removal And Installation - Suzuki 2006 SX4 Service Manual

2B-5 Front Suspension:

Front Strut Assembly Removal and Installation

CAUTION
!
When rebound stopper and strut assembly
were removed, check strut support lower nut
for specified torque before installing strut
assembly.
Removal
1) Remove hood rear seal (1), and then remove cowl
top garnish (2) from vehicle.
2
NOTE
When servicing component parts of strut
assembly, beforehand loosen strut nut a little
before removing strut assembly. This will
make service work easier. Note that the nut
must not be removed at this point.
2) Hoist vehicle, allowing front suspension to hang free.
3) Remove wheel and disconnect stabilizer joint (1)
from strut bracket.
When loosening joint nut, hold stud with hexagon
wrench (2).
2
4) Remove brake hose mounting bolt (1). Remove
S6RW0C2206003
5) Remove strut bracket bolts and nuts (4).
6) Remove strut nut (1), and remove rebound stopper
1
I5RW0A220003-01
7) Remove strut assembly.
Installation
Install strut assembly by reversing removal procedure,
noting the following instructions.
• Insert bolts in such direction as shown in figure.
• Tighten all fasteners to specified torque.
1
I5RW0A220004-01
brake hose (2) from bracket and wheel speed sensor
harness (3) from strut bracket as shown in figure.
3
1
2
(2).
NOTE
Hold strut by hand so that it will not fall off.
Tightening torque
Strut bracket nut (a): 140 N·m (14.0 kgf-m, 101.5
lb-ft)
Brake hose mounting bolt (c): 26 N·m (2.6 kgf-m,
19.0 lb-ft)
Stabilizer joint nut (d): 50 N·m (5.0 kgf-m, 36.5 lb-
ft)
CAUTION
!
Never reuse the removed strut bracket nut.
4
I5RW0A220005-01
2
1
I4RS0A220006-01