Cranking System Specifications
Voltage
Output
Rating
Direction of rotation
Brush length
Number of pinion teeth
Performance
Around at 20 °C
No load characteristic
(68 °F)
Load characteristic
Locked characteristic
Magnetic switch operating voltage
Tightening Torque Specifications
Fastening part
Battery cable nut
Starting motor mount bolt
NOTE
The specified tightening torque is also described in the following.
"Starting Motor Unit Components"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fasteners Information in Section 0A".
Recommended Service Material
NOTE
Required service material is also described in the following.
"Starting Motor Components"
Specifications
Clockwise as viewed from pinion side
Standard: 12.3 mm (0.48 in.)
Condition
90 A maximum
11.0 V
2,000 rpm minimum
11 N⋅m (1.1 kgf-m, 8.0 lb-ft) minimum
7.5 V 300 A
840 rpm minimum
860 A maximum
3.0 V
20 N⋅m (2.0 kgf-m, 14.5 lb-ft) minimum
N⋅m
11
25
Special Tools and Equipment
12 volts
1.4 kW
30 seconds
Guarantee
8 volts maximum
Tightening torque
kgf-m
lb-ft
1.1
8.0
2.5
18.5
Starting System:
S6RW0C1907001
Limit: 7.0 mm (0.28 in.)
8
S6RW0C1907002
Note
S6RW0C1908001
1I-9