Suzuki 2006 SX4 Service Manual page 251

5) Remove crankshaft pulley (1).
To remove crankshaft pulley, use special tools
(Steering wheel remover, Bearing puller attachment)
with it as shown in figure.
Special tool
(A): 09944–36011
(B): 09926–58010
6) Remove idler pulley (1), water pump pulley (2) and
belt tensioner (3).
7) Remove timing chain cover bolts (2) and nut (1).
8) Remove timing chain cover (3).
Installation
1) Clean sealing surfaces on timing chain cover,
cylinder block and cylinder head.
Remove oil, old sealant and dust from sealing
surface.
2) Install new oil seal (2) to timing chain cover using
special tool, if removed.
NOTE
When installing new oil seal (2), drive it until
its surface is flash with edge of timing chain
cover (1).
Special tool
(A): 09913–75510
I2RH01140052-01
I2RH01140054-01
I7RW01140041-01
Engine Mechanical: 1D-20
I2RH01140061-01