Suzuki 2006 SX4 Service Manual page 396

2B-11 Front Suspension:
3) Insert new hub bolt (1) in hub hole. Rotate hub bolt
slowly to assure that serrations are aligned with
those made by original bolt.
4) Drive in dust cover so that dimensions "a" and "b"
become equal as shown in figure.
CAUTION
!
When drive in dust cover, be careful not to
deform it.
5) Caulk more than 6 places with a punch.
6) Using special tool and hydraulic press, press fit
1
I7RW01220015-01
7) Apply grease lightly to end face of inner ring (1).
I2RH01220038-01
8) Install steering knuckle with wheel hub and bearing
I2RH01220039-01
wheel hub (1) into wheel bearing (2) (Face grooved
rubber seal side to wheel hub).
Special tool
(A): 09913–75510
"A": Grease 99000–25121 (SUZUKI Super
Grease H)
NOTE
Do not apply the grease to the encoder
section to avoid the encoder malfunction.
(1) so that foreign material should not enter wheel
speed sensing point "a".
2. Wheel encoder
3. Drive shaft
I7RW01220007-01
I5RW0B220001-01
I7RW01220008-02