Suzuki 2006 SX4 Service Manual page 725

65) Apply A/T fluid to new oil seal ring (1) and install oil
seal ring (1) to transaxle housing.
NOTE
Do not spread oil seal ring ends excessively.
66) Apply A/T fluid to transaxle rubrication tube (2).
67) Install tube clamp (3) and tighten the bolt to specified
torque.
Tightening torque
Transaxle lubrication tube bolt (a): 5.5 N·m (0.55
kgf-m, 4.0 lb-ft)
68) Install oil reservoir RH plate and tighten 3 bolts to
specified torque.
Tightening torque
Oil reservoir RH plate bolt (b): 5.5 N·m (0.55 kgf-
m, 4.0 lb-ft)
1
69) Install oil reservoir LH plate (1) and tighten 2 bolts to
specified torque.
Tightening torque
Oil reservoir LH plate bolts (a): 5.5 N·m (0.55
kgf-m, 4.0 lb-ft)
(a)
1
2
(a)
3
(b)
I4RH01510227-01
I4RH01510257-01
Automatic Transmission/Transaxle:
70) Install oil strainer assembly (1) and tighten the bolt to
specified torque.
Tightening torque
Oil strainer bolt (a): 5.5 N·m (0.55 kgf-m, 4.0 lb-
ft)
71) Install differential gear assembly.
(a)
1
72) Apply sealant to mating surface of transaxle case by
using a nozzle as shown in figure by such amount
that its section is 1.5 mm (0.059 in.) in diameter.
"A": Sealant 99000–31230 (SUZUKI Bond
No.1216B)
"A"
5A-137
I4RH01510228-01
I4RH01510229-01