Suzuki 2006 SX4 Service Manual page 723

44) Measure 1st / reverse brake piston stroke while
applying and releasing compressed air (400 – 800
kPa, 4 – 8 kg/cm 2 , 57 – 113 psi) through oil hole (1)
by using special tools. If measured piston stroke
exceeds specified value, check for an important
installation.
Special tool
(A): 09900–20607
(B): 09900–20701
1st / reverse brake piston stroke
Standard: 1.35 – 2.15 mm (0.053 – 0.085 in.)
1
45) Apply petroleum jelly to front planetary carrier rear
thrust bearing race (1).
46) Place front planetary carrier rear thrust bearing race
(1) onto planetary front gear (2).
47) Install planetary front gear (2) to front planetary ring
gear (3).
3
48) Apply petroleum jelly to input shaft front thrust
bearing (1) and rear planetary ring gear rear thrust
bearing (2).
49) Install input shaft front thrust bearing (1), planetary
(B)
(A)
50) Apply petroleum jelly to rear planetary ring gear rear
51) Install rear planetary ring gear rear thrust bearing
I4RH01510217-01
1
2
52) Install forward and direct clutch assembly (1).
I4RH01510218-01
53) Apply petroleum jelly to input shaft thrust bearing
54) Place input shaft rear thrust bearing front race (2)
Automatic Transmission/Transaxle:
sun gear (3), and rear planetary ring gear rear thrust
bearing (2) to forward and direct clutch assembly (4).
4
1
thrust bearing race and front planetary carrier rear
thrust bearing.
race (1), rear planetary ring gear (2) and front
planetary carrier rear thrust bearing (3) to planetary
sun gear (4).
NOTE
Make sure that tube of rear planetary ring
gear rear thrust bearing race fit into notch of
rear planetary ring gear.
4
front race (2) and input shaft rear thrust bearing (3).
and input shaft rear thrust bearing (3) to forward and
direct clutch assembly (1).
2
3
1
5A-135
2
3
I4RH01510219-01
3
2
1
I4RH01510220-01
I4RH01510221-01