Suzuki 2006 SX4 Service Manual page 609

DTC No. Detecting item
Shift Solenoid "B"
P0756
Performance or Stuck Off
P0757 Shift Solenoid "B" Stuck On
Pressure Control Solenoid "A"
P0961 Control Circuit Range/
Performance
Pressure Control Solenoid "A"
P0962
Control Circuit Low
Pressure Control Solenoid "A"
P0963
Control Circuit High
Shift Solenoid "A" Control
P0973
Circuit Low
Shift Solenoid "A" Control
P0974
Circuit High
Shift Solenoid "B" Control
P0976
Circuit Low
Shift Solenoid "B" Control
P0977
Circuit High
Internal Control Module
P1702
Memory Check Sum Error
Range Select Switch
P1723
Malfunction
Torque Converter Clutch
P2763 Pressure Control Solenoid
Control Circuit High
Torque Converter Clutch
P2764 Pressure Control Solenoid
Control Circuit Low
Control Module
U0073
Communication Bus Off
Lost Communication With
U0100
ECM / PCM "A"
Automatic Transmission/Transaxle:
Detecting condition
(DTC will set when detecting:)
Actual gear position is different from commanded
gear position of TCM (Shift solenoid valve – B
does not turn ON).
Actual gear position is different from commanded
gear position of TCM (Shift solenoid valve – B
does not turn OFF).
Difference between actual current of pressure
control solenoid valve and current of pressure
control solenoid valve calculated by TCM is more
than specification.
Value of pressure control solenoid valve output
current is too low for 12.5 seconds or more.
Value of pressure control solenoid valve output
current is too high for 12.5 seconds or more.
Difference between command signal and monitor
signal of shift solenoid valve – A (shift solenoid
valve – A circuit is shorted to ground).
Difference between command signal and monitor
signal of shift solenoid valve – A (shift solenoid
valve – A circuit is open or shorted to power
supply circuit).
Difference between command signal and monitor
signal of shift solenoid valve – B (shift solenoid
valve – B circuit is shorted to ground).
Difference between command signal and monitor
signal of shift solenoid valve – B (shift solenoid
valve – B circuit is open or shorted to power
supply circuit).
Data write error or check sum error.
"3" position switch ON signal is inputted although
transmission range sensor signal is inputted P, R,
N or L range.
Difference between command signal and monitor
signal of TCC lock-up solenoid valve (TCC lock-
up solenoid valve circuit is open or shorted to
power supply circuit).
Difference between command signal and monitor
signal of TCC lock-up solenoid valve (TCC lock-
up solenoid valve circuit is shorted to ground).
Transmission error that is inconsistent between
transmission data and transmission monitor
(CAN bus monitor) data is detected more than 30
times continuously.
Reception error of communication data for ECM
is detected for longer than specified time
continuously.
5A-21
A B
2 driving 2 driving
cycles cycles*
2 driving 2 driving
cycles cycles*
1 driving 1 driving
cycle cycle
1 driving 1 driving
cycle cycle
1 driving 1 driving
cycle cycle
1 driving 1 driving
cycle cycle
1 driving 1 driving
cycle cycle
1 driving 1 driving
cycle cycle
1 driving 1 driving
cycle cycle
1 driving 1 driving
cycle cycle
1 driving 1 driving
cycle* cycle*
1 driving 1 driving
cycle cycle
1 driving 1 driving
cycle cycle
1 driving 1 driving
cycle cycle
1 driving 1 driving
cycle cycle