Desiccant Removal And Installation - Suzuki 2006 SX4 Service Manual

5) Move condenser assembly from the vehicle in the
arrow direction in the order of 1, 2 and 3 as shown,
and it can be removed.
"1"
"2"
"3"
Installation
Reverse the removal procedure to install condenser
noting the following instructions.
• Replenish specified amount of compressor oil to
compressor suction side referring to "Replenishing
Compressor Oil" in "Operation Procedure for
Refrigerant Charge".
• Evacuate and charge the A/C system referring to
"Evacuation" and "Charge" in "Operation Procedure
for Refrigerant Charge".

Desiccant Removal and Installation

Removal
1) Remove condenser assembly referring to
"Condenser Assembly Removal and Installation".
2) Remove circlip (4) using special tool.
Special tool
: 09900–06107
3) Remove the cap (1) from the receiver / dryer tank
(2).
4) Remove desiccant (3).
2
I5RW0A721021-02
S6RW0C7216006
3
1
4
I5RW0A721022-01
Air Conditioning System: Manual Type 7B-24
Installation
Reverse the removal procedure noting the following
instructions.
• Replenish specified amount of compressor oil to
compressor suction side referring to "Operation
Procedure for Refrigerant Charge".
• Do not remove desiccant from the plastic bag until just
before inserting it into the receiver.
• Apply compressor oil to O-ring (1).
• Be sure to install circlip (2) with its flat face (3)
directed to cap.
• Install condenser assembly referring to "Condenser
Assembly Removal and Installation".
• Evacuate and charge the A/C system referring to
"Evacuation" and "Charge" in "Operation Procedure
for Refrigerant Charge".
: Do not reuse
1
2
3
I5RW0A721052-01