Master Cylinder Inspection - Suzuki 2006 SX4 Service Manual

4A-13 Brake Control System and Diagnosis:
3) Drain brake fluid in reservoir.
4) Disconnect clutch reservoir hose from reservoir (M/T
model).
5) Disconnect brake pipes (1) connected to master
cylinder.
6) Remove master cylinder fixing nuts (2).
7) Remove master cylinder (3) and O-ring.
Installation
1) Install new O-ring (2) to master cylinder assembly
(1).
2) Apply grease to piston rod "A".
Use specified grease in spare to master cylinder or
brake booster as supply parts.
3) Install master cylinder assembly (1) to brake booster
(3) and tighten master cylinder fixing nuts to
specified torque.
Tightening torque
Master cylinder fixing nut (a): 18 N·m (1.8 kgf-
m, 13.0 lb-ft)
3
1
2
(a)
2
1
3
I7RW01410012-01
"A"
I7RW01410019-01
4) Connect brake pipe to master cylinder and tighten
flare nuts to specified torque.
Tightening torque
Brake pipe flare nut (a): 16 N·m (1.6 kgf-m, 11.5
lb-ft)
5) Connect clutch reservoir hose to reservoir and install
reservoir hose clamp (M/T model).
6) Connect fluid level switch connector and clamp.
7) Fill reservoir with specified brake fluid up to its MAX
level.
8) After completing the work, bleed air from brake and
clutch system referring to "Air Bleeding of Brake
System" and bleed air from clutch system referring to
"Air Bleeding of Clutch System in Section 5C" (M/T
model).
9) Check each installed parts for fluid leakage.
10) Check brake pedal for play referring to "Brake Pedal
Play Inspection".
11) Perform brake test and check fluid leakage.

Master Cylinder Inspection

• Depress brake pedal a few times and retain brake
pedal. If pedal gone down, replace the brake master
cylinder assembly.
• Check master cylinder for leakage, corrosion and
smooth operation.
• Inspect distance "a" to be the following.
If measurement is out of specification, replace master
cylinder assembly.
Distance
"a": 72.0 mm (2.83 in.) or more
(a)
I7RW01410013-01
S6RW0C4106013
I7RW01410014-01