Suzuki 2006 SX4 Service Manual page 728

5A-140 Automatic Transmission/Transaxle:
85) Apply sealant to mating surface of transaxle case by
using a nozzle as shown in figure by such amount
that its section is 1.5 mm (0.059 in.) in diameter.
"A": Sealant 99000–31230 (SUZUKI Bond
No.1216B)
86) Install transaxle side cover (1) by tightening new
®
torx bolts to specified torque.
Tightening torque
Transaxle side cover bolts (a): 13 N·m (1.3 kgf-
m, 9.5 lb-ft)
(a)
"A"
I4RH01510237-01
(a)
1
(a)
(a)
I4RH01510238-01
87) Apply A/T fluid to transmission fluid temperature
sensor (1), output shaft speed sensor (2), input shaft
speed sensor (3) and fluid filler tube (4).
88) Install input shaft speed sensor and output shaft
speed sensor (with new O-rings installed) by
tightening bolts to specified torque.
Tightening torque
Input shaft speed sensor bolt (a): 5.5 N·m (0.55
kgf-m, 4.0 lb-ft)
Output shaft speed sensor bolt (b): 5.5 N·m (
0.55 kgf-m, 4.0 lb-ft)
89) Install fluid filler tube (4) (with new O-ring installed).
90) Install transmission fluid temperature sensor (1)
(with new O-ring installed) to specified torque.
Tightening torque
Transmission fluid temperature sensor (d): 10
N·m (1.0 kgf-m, 7.2 lb-ft)
3, (a)
4
2, (b)
(c)
1, (d)
I7RW01510058-01