Suzuki 2006 SX4 Service Manual page 686

5A-98 Automatic Transmission/Transaxle:
12) Remove oil pump plate (1), driven gear (2) and drive
gear (3).
13) Remove O-ring.
14) Remove oil pump oil seal (1), using special tool.
Special tool
(A): 09913–50121
NOTE
Never reuse removed oil seal.
1
Reassembly
1) Press-fit new oil pump oil seal (1) using special tool
and hammer and then apply grease to its lip portion.
Special tool
(A): 09913–85210
: Grease 99000–25030 (SUZUKI Super Grease C)
1
2
3
I4RH01510097-01
(A)
I4RH01510098-01
(A)
1
I4RH01510099-01
2) After applying A/T fluid to gears, install driven gear
(1) and drive gear (2) to oil pump body (3) aligning
marks on the gears.
3) Apply A/T fluid to new O-ring (4) and install it to oil
pump body.
4) Install oil pump plate (5).
4
5) Install stator shaft (1) to oil pump body and tighten
bolts (2) to specification.
Tightening torque
Oil pump cover bolts (a): 6.5 N·m (0.65 kgf-m,
4.7 lb-ft)
Oil pump cover bolts (b): 12 N·m (1.2 kgf-m, 8.7
lb-ft)
2, (b)
2, (a)
2, (b)
6) After applying A/T fluid to new O-rings and install it to
2nd brake piston.
7) Press 2nd brake piston into starter shaft.
NOTE
Do not twist or deviate O-rings during
installation.
5
1
2
3
I4RH01510100-01
2, (b)
1
2, (b)
I4RH01510096-01
I4RH01510101-01