Transmission Control Module (Tcm) Removal And Installation; Differential Side Oil Seal Replacement - Suzuki 2006 SX4 Service Manual

Transmission Control Module (TCM) Removal
and Installation
CAUTION
!
TCM consists of highly precise parts,
therefore when handling it, be careful not to
expose to excessive shock.
Removal
1) Disconnect negative cable at battery.
2) If the vehicle is equipped with air bag system,
disable air bag system. Refer to "Disabling Air Bag
System in Section 8B".
3) Remove glove box.
4) Disconnect connectors from TCM (1).
5) Remove TCM by removing its nuts.
Installation
Reverse removal procedure noting the following.
• Connect TCM connectors securely.
• If the vehicle is equipped with air bag system, be sure
to enable air bag system after TCM is back in place.
Refer to "Enabling Air Bag System in Section 8B".

Differential Side Oil Seal Replacement

1) Lift up vehicle and drain A/T fluid.
S6RW0C5106024
2) Remove drive shaft joints from differential gear of
transaxle. Refer to "Front Drive Shaft Assembly
Removal and Installation in Section 3A" for
procedure to disconnect drive shaft joints.
For differential side oil seal removal, it is not
necessary to remove drive shafts from steering
knuckle.
3) Remove differential side oil seal by using screw
driver or the like.
4) Apply grease to new differential side oil seal lip.
: Grease 99000–25030 (SUZUKI Super Grease C)
5) Press-fit new differential side oil seal (1) until
transaxle case end face (2) is flush with oil seal end,
using special tool.
Special tool
(A): 09924–07730
1
I5RW0C510040-01
6) Install drive shaft referring to "Front Drive Shaft
Assembly Removal and Installation in Section 3A".
7) Pour A/T fluid referring to "A/T Fluid Change".
Automatic Transmission/Transaxle:
1
(A)
5A-81
S6RW0C5106025
2
I4RH01510047-01