Suzuki 2006 SX4 Service Manual page 421

Wheel Discs Inspection
Inspect each wheel disc for dents, distortion and cracks.
A disc in badly damaged condition must be replaced.
Tires Inspection
1) Check tires for uneven or excessive wear, or
damage referring to "Irregular and/or Premature
Wear Description" and "Wear Indicators Description"
for details.
2) Rotate tires. For details, refer to "Tire Rotation".
Wheel Balance Inspection and Adjustment
Refer to "Balancing Wheels Description".
Deposits of mud, etc. must be cleaned from inside of rim.
WARNING
!
Stones should be removed from the tread in
order to avoid operator injury during spin
balancing and to obtain good balance.
Each tire should be inspected for any damage, then
balanced according to equipment manufacturer's
recommendation.
Off-Vehicle Balancing
Most electronic off-vehicle balancers are more accurate
than the on-vehicle spin balancers. They are easy to use
and give a dynamic (two plane) balance. Although they
do not correct for drum or disc unbalance as does on-
vehicle spin balancing, this is overcome by their
accuracy, usually to within 1/8 ounce.
On-Vehicle Balancing
On-vehicle balancing methods vary with equipment and
tool manufacturers. Be sure to follow each
manufacturer's instructions during balancing operation.
WARNING
!
Wheel spin should be limited to 55 km/h (35
mph) as indicated on speedometer.
This limit is necessary because speedometer
only indicates one-half of actual wheel speed
when one drive wheel is spinning and the
other drive wheel is stopped.
Unless care is taken in limiting drive wheel
spin, spinning wheel can reach excessive
speeds. This can result in possible tire
disintegration or differential failure, which
could cause serious personal injury or
extensive vehicle damage.
Repair Instructions
CAUTION
!
S6RW0C2406006
For vehicle equipped with ABS, using on-
vehicle balancing method with ignition
switch ON may set malfunction diagnostic
trouble code (DTC) of ABS even when system
S6RW0C2406007 is in good condition.
Never turn ignition switch ON while spinning
wheel.
Tire Rotation
To equalize wear, rotate tires periodically as shown in
figure.
S6RW0C2406001
Refer to "Wheel (with Tire) Removal and Installation".
F: Forward
Wheel (with Tire) Removal and Installation
Removal
CAUTION
!
Never use heat to loosen tight wheel because
the application of heat to wheel causes the
wheel life shorter and the wheel bearing
damage.
1) Loosen wheel nuts by approximately 180° (half a
rotation).
2) Hoist vehicle.
3) Make sure that the vehicle will not fall off by trying to
move vehicle body in both ways.
4) Remove wheel nuts except one.
5) Support the wheel and/or tire not to drop the wheel
and then remove the nut left with the wheel.
Wheels and Tires: 2D-5
S6RW0C2406002
I7RW01240001-02
S6RW0C2406003