Suzuki 2006 SX4 Service Manual page 1028

8B-63 Air Bag System:
Step
3 Floor harness circuit check
1) Disconnect applicable "L384" or "L385" connector under
front cushion.
2) Check for proper connection to applicable floor harness
connector at terminal in connector "L384" or "L385".
3) If OK, release shorting bar in SDM connector inserting
release tool (1) included in special tool (A).
Special tool
(A): 09932–76010
4) Measure resistance between "L04-11" terminal and body
ground, and between "L04-12" terminal and body ground
(for DTC B1063).
5) Measure resistance between "L04-13" terminal and body
ground, and between "L04-14" terminal and body ground
(for DTC B1067).
"L04-11" "L04-12" "L04-13" "L04-14"
(A)
Is each measured resistance infinity?
NOTE
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components, ensure all components are properly mounted.
• Clear DTCs referring to "DTC Clearance", if any.
• Repeat "Air Bag Diagnostic System Check" to confirm that the trouble has been corrected.
Action
"L384", "L385"
1,(A)
I7RW01822083-01
Yes
DTC B1063: Repair
"BLU" circuit or "BLK"
circuit for short to
ground at driver side-air
bag harness.
DTC B1067: Repair
"BLU" circuit or "BLK"
circuit for short to
ground at passenger
side-air bag harness.
No
DTC B1063: Repair
"GRY/RED" circuit or
"GRY" circuit for short to
ground at floor harness.
DTC B1067: Repair
"BRN/WHT" circuit or
"BRN" circuit for short to
ground at floor harness.