Steering Lock Assembly (Ignition Switch) Removal And Installation - Suzuki 2006 SX4 Service Manual

6B-9 Steering Wheel and Column:
Steering Lock Assembly (Ignition Switch)
Removal and Installation
Removal
1) Remove steering column. Refer to "Steering Column
Removal and Installation".
2) Using center punch (1), loosen and remove steering
lock mounting bolts (2).
NOTE
Use care not to damage aluminum part of
steering lock body with center punch.
3) Turn ignition key to "ACC" or "ON" position and
remove steering lock assembly from steering
column.
Installation
1) Position oblong hole (1) of steering shaft (2) in the
S6RW0C6206011
center of hole (3) in column (4).
2) Turn ignition key to "ACC" or "ON" position and
install steering lock assembly (5) onto column (4).
3) Now turn ignition key to "LOCK" position and pull it
out.
4) Align hub on lock with oblong hole (1) of steering
shaft (2) and rotate shaft to assure that steering shaft
is locked.
5) Tighten new bolts (1) until head of each bolt is
broken off.
6) Turn ignition key to "ACC" or "ON" position and
I4RS0B620005-02
check to be sure that steering shaft (2) rotates
smoothly. Also check for lock operation.
7) Install steering column. Refer to "Steering Column
Removal and Installation".
8) (Keyless start model)
If steering lock assembly has replaced, after
completing installation, register steering lock unit ID
code to keyless start control module as following.
• Immobilizer model:
Register ignition key transponder code in ECM
referring to "Registration of the Ignition Key in
Section 10C".
• Non-immobilizer model:
Register steering lock unit ID code in keyless start
control module referring to "Keyless Start
Registration in Section 10E".
2
1
4
3
5
I4RS0B620006-02
I4RS0B620007-02