Suzuki 2006 SX4 Service Manual page 465

Terminal arrangement of 4WD control module connector (Viewed from harness side)
Terminal
Wire Color
Number
G26-1 —
Coupling assembly
G26-2 GRN
(ground)
Coupling assembly
G26-3 YEL
(power)
G26-4 —
G26-5 —
G26-6 —
G26-7 —
G26-8 —
G26-9 —
G26-10 BLK Ground
Power source for
G26-11 WHT/RED
internal memory
G26-12 RED/BLK Power source
G26-13 RED/WHT 4WD switch
G26-14 GRN/YEL 4WD lock switch
G26-15 —
G26-16 —
G26-17 —
G26-18 —
G26-19 —
G26-20 —
Data link connector
G26-21 BLU
(DLC)
CAN communication
G26-22 RED
line (High)
CAN communication
G26-23 WHT
line (Low)
12 11 10 9 8
26 25 24 23 22 21 20
Normal
Circuit
Voltage
— —
About 5 V Ignition switch turned ON position
10 – 12 V
*0 – 12 V
("Reference
waveform
No.1: ")
About 5 V Above-mentioned condition
— —
— —
— —
— —
— —
— —
0 – 1 V
10 – 14 V
10 – 14 V Ignition switch turned ON position
0 – 1 V
10 – 14 V
0 – 1 V
10 – 14 V
— —
— —
— —
— —
— —
— —
10 – 14 V Ignition switch turned ON position
*2.5 – 3.6 V
("Reference
waveform
No.2: ")
*1.6 – 2.5 V
("Reference
waveform
No.2: ")
7 6 5 4 3 2
19 18 17 16 15 14
• Run engine at idle speed and 2WD/4WD switch at
4WD lock position
• Selector lever at "P" or "N" range (A/T model)
• Run engine at idle speed and 2WD/4WD switch at
4WD lock position
• Selector lever at other than "P" or "N" range (A/T
model) or depress accelerator pedal (M/T model)
Ignition switch turned ON position and 2WD/4WD
switch at 4WD auto or 4WD lock position
Ignition switch turned ON position and 2WD/4WD
switch at 2WD position
Ignition switch turned ON position and 2WD/4WD
switch kept pushing at 4WD lock position
Ignition switch turned ON position and 2WD/4WD
switch released at 4WD lock position
Ignition switch turned ON position
Ignition switch turned ON position
Differential:
1
13
I4JA01332054-01
Condition
—
—
—
—
—
—
—
—
—
—
—
—
—
—
—
3B-27