8) Install 2nd brake piston return spring.
9) Install cushion plate "C", separator plates "S", friction
plates "F" and retaining plate "R" with flat end facing
to friction plates side in the following order.
C → S → F → S → F → S → F → S → F → R
10) Install snap ring.
NOTE
Make sure that opening end of ring is not
aligned with groove section of starter shaft.
R
S
F
C
11) Apply A/T fluid to new O-rings and install them to
2nd coast brake piston.
12) Press 2nd coast brake piston (1) into starter shaft
(2).
NOTE
Do not twist or deviate O-rings during
installation.
13) Install 2nd coast brake piston return spring (1).
14) Using special tool and hydraulic press (2), compress
2nd coast brake piston return spring (1) until spring
seat is pushed down to 1 – 2 mm (0.039 – 0.078 in.)
lower than snap ring groove and install snap ring (3).
Special tool
(A): 09926–98350
!
Be careful when applying pressure, for
overpressure will cause plate section of
spring to deform.
NOTE
• When installing return spring, be careful
• Do not align opening in snap ring with lug
I4RH01510102-01
1
2
I4RH01510103-01
Automatic Transmission/Transaxle:
CAUTION
so that return spring will not fall or tilt.
of 2nd coast brake piston return spring at
its retainer section.
(A)
5A-99
2
1
3
I4RH01510104-01