Booster Push Clevis Rod Adjustment; Tightening Torque Specifications; Special Tool - Suzuki 2006 SX4 Service Manual

Booster Push Clevis Rod Adjustment

Install push clevis rod (1) so that measurement "a" is
obtained and torque nut (2) to specification.
Tightening torque
Clevis pin lock nut (a): 26 N·m (2.6 kgf-m, 19.0 lb-ft)
Clevis installing position (length "a")
"a": 129.5 - 130.5 mm (5.10 - 5.13 in.)

Tightening Torque Specifications

Fastening part
Front brake caliper bleeder plug
Rear brake caliper bleeder plug
Flexible hose joint bolt
Master cylinder fixing nut
Brake pipe flare nut
Booster mounting nut
Clevis pin lock nut
NOTE
The specified tightening torque is also described in the following.
"Front Brake Hose / Pipe Construction"
"Rear Brake Hose / Pipe Construction"
"Brake Pedal Components"
"Master Cylinder and Brake Booster Components"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fasteners Information in Section 0A".
Recommended Service Material
NOTE
Required service material is also described in the following.
"Master Cylinder and Brake Booster Components"

Special Tool

09916–44310
Valve guide remover (5 mm)
/
S6RW0C4106017
Specifications
N⋅m
9
9
23
18
16
13
26
Special Tools and Equipment
Brake Control System and Diagnosis:
Tightening torque
kgf-m lb-ft
0.9 6.5
0.9 6.5
2.3 17.0
1.8 13.0
1.6 11.5
1.3 9.5
2.6 19.0
4A-16
IYSQ01410050-01
S6RW0C4107001
Note
S6RW0C4108001
S6RW0C4108002