P/S Control Module Removal And Installation; Torque Sensor And Its Circuit Inspection - Suzuki 2006 SX4 Service Manual

6C-42 Power Assisted Steering System:

P/S Control Module Removal and Installation

Removal
1) Disconnect negative cable at battery.
2) Remove console box.
3) Disconnect connectors (1) from P/S control module.
4) Remove P/S control module and bracket (2) from
floor panel.
5) Separate P/S control module and bracket.
Installation
Reverse removal procedure.
S6RW0C6306011
1
2
I5RW0A630027-01

Torque Sensor and Its Circuit Inspection

1) Check that torque sensor circuit is in good condition
referring to Step 2 to 3 of "DTC C1111 / C1113 /
C1115: Torque Sensor Circuit Failure". If check result
is not satisfactory, repair torque sensor circuit.
2) Remove console box.
3) With ignition switch turned OFF, connect scan tool to
DLC or connect voltage tester between "E11-18" –
"E11-9" (main sensor) or "E11-10" – "E11-9" (sub
sensor) with connected connector to P/S control
module.
[A]
E11
[B]
E11
[A]: Main sensor
4) Set torque wrench to steering wheel referring to
"Steering Force Check" for checking steering force.
S6RW0C6306012
18 18
9
10
9
I7RW01632021-01
[B]: Sub sensor
I3RM0A630022-01