Passenger Air Bag (Inflator) Module Repair Harness Installation - Suzuki 2006 SX4 Service Manual

Passenger Air Bag (Inflator) Module Repair
Harness Installation
Replace passenger air bag (inflator) module repair
harness (2) according to the following procedure when
the harness (9) connected with passenger air bag
(inflator) module of the air bag harness included in
instrument panel harness (7) and passenger air bag
(inflator) module connector (1) is damaged.
4
3
4
3
3. Driver air bag (inflator) module
4. Passenger air bag (inflator) module
5. Floor harness
6. Vinyl tape
7. Instrument panel harness
8. Floor harness joint (yellow) connector with passenger air bag (inflator)
module of air bag harness included in instrument panel harness
10. Floor harness joint (yellow) connector of passenger air bag (inflator)
module repair harness
S6RW0C8206017
1
7
8
9
5
2
7
6
6
10
5
I5RW0C820001-01
1) Disable air bag system. Refer to "Disabling Air Bag
System".
2) Remove passenger air bag (inflator) module
referring to "Passenger Air Bag (Inflator) Module
Removal and Installation" if it has installed.
3) Disconnect floor harness joint (yellow) connector (1)
with passenger air bag (inflator) module of air bag
harness included in instrument panel harness from
floor harness located near the glove box.
1
4) Cut off passenger air bag (inflator) module connector
(1) and floor harness joint (yellow) connector (2) with
passenger air bag (inflator) module of air bag
harness included in instrument panel harness as
shown, and then fasten it to instrument panel
harness with vinyl tape for avoiding interference with
other parts.
2
Air Bag System: 8B-106
I5RW0C820002-01
1
I5RW0C820003-01