Centering Contact Coil Cable Assembly; Contact Coil Cable Assembly Inspection; Steering Column Removal And Installation - Suzuki 2006 SX4 Service Manual

Hide thumbs Also See for 2006 SX4:
Table of Contents

Advertisement

3) Install steering column upper cover (1) and lower
cover (2).
CAUTION
!
When installing covers, be careful so that
each lead wire is not caught between covers.
Otherwise, each lead wire is damaged.
2
3. Standard screw
4) Install steering wheel to steering column. Refer to
"Steering Wheel Removal and Installation".
5) Connect negative (–) cable to battery.
6) Enable air bag system referring to "Enabling Air Bag
System in Section 8B".

Centering Contact Coil Cable Assembly

1) Check that vehicle's wheels (front tires) are set at
straight-ahead position.
2) Check that ignition switch is at LOCK position.
3) Turn contact coil counterclockwise slowly with a light
force till contact coil will not turn any further.
NOTE
Contact coil can turn about 5 turns at the
maximum, that is, if it is at the center
position, can turn about two and a half turns
both clockwise and counterclockwise.
1
4
3
I6RW0B620003-01
4. Tapping screw
S6RW0C6206004
I4RS0A620012-01
Steering Wheel and Column:
4) From the position where contact coil became unable
to turn any further (it stopped), turn it back clockwise
about two and a half rotations and align center mark
with alignment mark (1).
1

Contact Coil Cable Assembly Inspection

Refer to "Contact Coil Cable and Its Circuit Check in
Section 8B".

Steering Column Removal and Installation

CAUTION
!
Once the steering column is removed from
the vehicle, the column is extremely
susceptible to damage.
• Dropping the column assembly on its end
could collapse the steering shaft or loosen
the plastic shear pins which maintain
column length.
• Leaning on the column assembly could
cause it to bend or deform.
Any of the damage could impair the column's
collapsible design.
Steering column mounting nuts should not
be loosened with steering shaft joint upper
side bolt tightened as this could cause
damage to shaft joint bearing.
NOTE
When servicing steering column or any
column-mounted component, remove
steering wheel. But when removing steering
column simply to gain access to instrument
panel components, leave steering wheel
installed on steering column.
6B-6
I4RS0A620013-01
S6RW0C6206005
S6RW0C6206008

Advertisement

Table of Contents
loading

Table of Contents