Suzuki 2006 SX4 Service Manual page 720

5A-132 Automatic Transmission/Transaxle:
11) Apply special tools and push in underdrive brake
piston cover (1).
Special tool
(A): 09916–14510
(B): 09916–14910
12) Install snap ring (2), using pliers or the like.
2
(B)
13) Install underdrive brake band (1).
1
14) Apply A/T fluid to new O-ring (1) and install new O-
ring (1) to underdrive brake band anchor bolt (2).
15) Tighten underdrive brake band anchor bolt (2) to
specified torque, using special tool.
Special tool
(A): 09927–68010
Tightening torque
Underdrive brake band anchor bolt (a): 170 N·m
(17.0 kgf-m, 123.0 lb-ft)
16) Remove oil plug bolt with O-ring installed (3).
3
1
(A)
I4RH01510201-01
I4RH01510202-01
2
1, (a)
I7RW01510063-02
17) Measure underdrive brake piston stroke while
applying and releasing compressed air (400 – 800
kPa, 4 – 8 kg/cm 2 , 57 – 113 psi) through oil hole (2).
If measured piston stroke exceeds specified value,
replace underdrive brake piston rod in the following
so as piston stroke to be in standard value. If piston
stroke is still standard value or more, replace
underdrive brake band with a new one.
Underdrive brake piston stroke
Standard: 5.48 – 7.02 mm (0.26 – 0.28 in.)
Available underdrive brake piston rod length
70.5 mm (2.776 in.), 72.0 mm (2.835 in.)
1. Underdrive brake piston
18) Apply A/T fluid to new O-ring and install O-ring to oil
plug bolt (1).
19) Tighten oil plug bolt to specified torque.
Tightening torque
Underdrive brake oil plug bolt: 7.5 N·m (0.75
kgf-m, 5.5 lb-ft)
1
1
2
I5RH01510020-01
I4RH01510205-01