Rear Brake Disc Inspection - Suzuki 2006 SX4 Service Manual

Installation
Install in reverse order of removal nothing the following.
• Tighten caliper carrier bolts to specified torque.
Tightening torque
Caliper carrier bolt (a): 60 N·m (6.0 kgf-m, 43.5 lb-
ft)
• Install rear wheel referring to "Wheel (with Tire)
Removal and Installation in Section 2D".
• Upon completion of installation, perform brake test.

Rear Brake Disc Inspection

• Using magnetic stand and with dial gauge positioned
at about 10 mm (0.39 in.) inward from periphery of
disc, measure deflection of disc.
If limit value is exceeded, replace correct or replace.
Rear brake disc deflection
Limit: 0.10 mm (0.004 in.) max.
Tightening Torque Specifications
Fastening part
Caliper pin bolt
Brake caliper carrier bolt
Flexible hose joint bolt
Brake pipe flare nut
Parking nut
Caliper carrier bolt
NOTE
The specified tightening torque is also described in the following.
"Rear Disc Brake Components"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fasteners Information in Section 0A".
Special tool
(A): 09900–20607
(B): 09900–20701
(a)
• Using micrometer, measure thickness of brake disc.
If limit value is exceeded, replace brake disc.
I7RW01432013-01 Rear brake disc thickness
Standard: 9 mm (0.354 in.)
Limit: 8 mm (0.315 in.)
S6RW0C4306008
Specifications
Tightening torque
N⋅m
23
60
23
16
27
60
kgf-m lb-ft
2.3 17
6.0 43.5
2.3 17.0
1.6 12.0
2.7 19.5
6.0 43.5
Rear Brakes: 4C-8
(B)
(A)
I6RS0B431031-01
I6RS0B431032-01
S6RW0C4307001
Note