Rear Brake Hose / Pipe Removal And Installation; Brake Hose And Pipe Inspection - Suzuki 2006 SX4 Service Manual

Installation
Reverse brake flexible hose removal procedure, noting
the following.
• Make sure that steering wheel is in straight-forward
position and flexible hose has not twist or kink.
• Install clamps and tighten nuts referring to "Front
Brake Hose / Pipe Construction".
• Install brake flexible hose (1) to caliper as shown in
figure.
Tightening torque
Flexible hose joint bolt (a): 23 N·m (2.3 kgf-m,
17.0 lb-ft)
2. Location mark
3. Outside of vehicle
4. Inside of vehicle
• Check to make sure that flexible hose doesn't contact
any part of suspension, both in extreme right and
extreme left turn conditions. If it does at any point,
remove and correct. Fill and maintain brake fluid level
in reservoir.
• Bleed brake system. Refer to "Air Bleeding of Brake
System".
• Perform brake test and check installed part for fluid
leakage.
Brake Control System and Diagnosis:
Rear Brake Hose / Pipe Removal and
Installation
CAUTION
!
Do not allow brake fluid to get on painted
surfaces. Painted surfaces will be damaged
by brake fluid, flush it with water immediately
if any fluid is spilled.
Removal
1) Raise and support vehicle properly. Remove tire and
wheel.
2) Clean dirt and foreign material from both flexible
hose end and pipe end fittings.
3) Drain brake fluid in reservoir.
4) Remove brake flexible hose or pipe.
Installation
Reverse brake flexible hose removal procedure, noting
the following.
• Install clamps and tighten nuts referring to "Rear
Brake Hose / Pipe Construction".
• Fill and maintain brake fluid level in reservoir.
• Bleed brake system. Refer to "Air Bleeding of Brake
System".
• Perform brake test and check each installed part for
fluid leakage.
• When installing hose, make sure that it has no twist or
kink.

Brake Hose and Pipe Inspection

Hose
The brake hose assembly should be checked for road
hazard damage, for cracks and chafing of outer cover,
for leaks and blisters. A light and mirror may be needed
for an adequate inspection. If any above conditions are
observed on brake hose, it is necessary to replace it.
I7RW01410007-02
Pipe
Inspect the pipe for damage, cracks, dents and
corrosion. If any defect is found, replace it.
4A-10
S6RW0C4106008
S6RW0C4106009
I5RW0A410007-01