Suzuki 2006 SX4 Service Manual page 695

5) Using special tool and hydraulic press, compress
direct clutch piston return spring and remove snap
ring (1).
Special tool
(A): 09926–95420
(B): 09940–51710
CAUTION
!
Be careful when applying pressure, for
overpressure will cause plate section of
direct clutch piston return spring to deform.
6) Remove direct clutch piston return spring (2).
7) For removing forward clutch piston and direct clutch
piston, install forward and direct clutch assembly (1)
to transaxle rear cover (2).
8) Remove direct clutch piston (3) with O-rings by
applying compressed air (400 – 800 kPa, 4 – 8 kg/
cm 2 , 57 – 113 psi) through oil hole (4).
NOTE
If piston does not pop out, it is recommended
to use needle-nose pliers for removal.
4
(B)
(A)
2
1
I4RH01510259-01
1
3
2
I4RH01510111-01
Automatic Transmission/Transaxle:
9) Remove forward clutch piston (1) with O-rings by
applying compressed air (400 – 800 kPa, 4 – 8 kg/
cm 2 , 57 – 133 psi) from through oil hole (2).
NOTE
If piston does not pop out, it is recommended
to use needle-nose pliers for removal.
10) Remove oil seal ring (1) from input shaft (2).
NOTE
Never reuse removed oil seal ring.
2
1
Reassembly
1) Apply A/T fluid to new oil seal ring and install new oil
seal ring (1) to input shaft (2).
2
1
5A-107
1
2
I4RH01510250-01
I4RH01510125-01
I4RH01510125-01