Manual Transaxle Oil Change - Suzuki 2006 SX4 Service Manual

Manual Transaxle Oil Change

1) Before changing oil, be sure to stop engine and lift
vehicle horizontally.
2) With vehicle lifted up, check leakage.
If leakage exists, correct it.
NOTE
Whenever vehicle is hoisted for any other
service work than oil change, also be sure to
check for oil leakage.
3) Remove oil level / filler plug (2).
4) Remove drain plug (1), and drain old oil.
5) Apply sealant to thread of drain plug (1), and tighten
it to specified torque.
"A": Sealant 99000–31260 (SUZUKI Bond
No.1217G)
Tightening torque
Transaxle oil drain plug (a): 21 N·m (2.1 kgf-m,
15.5 lb-ft)
6) Pour new specified oil until oil level reaches bottom
of oil filler plug hole (3) as shown in figure.
NOTE
It is highly recommended to use API GL-4
75W-90 gear oil.
Transaxle oil specification
: API GL-4 (For SAE classification, refer to
viscosity chart [A] in figure.)
Transaxle oil capacity
Reference: 2.5 liters (5.3/4.4 US/lmp. pt.)
7) Apply sealant to thread of level / filler plug, and then
S6RW0C5206002
tighten it to specified torque.
"A": Sealant 99000–31260 (SUZUKI Bond
No.1217G)
Tightening torque
Transaxle oil level / filler plug (b): 21 N·m (2.1
kgf-m, 15.5 lb-ft)
Manual Transmission/Transaxle: 5B-7
I5RW0A520005-01