Dtc P0962: Pressure Control Solenoid "A" Control Circuit Low - Suzuki 2006 SX4 Service Manual

5A-50 Automatic Transmission/Transaxle:

DTC P0962: Pressure Control Solenoid "A" Control Circuit Low

Wiring Diagram
Refer to "DTC P0961: Pressure Control Solenoid "A" Control Circuit Range / Performance".
DTC Detecting Condition and Trouble Area
DTC detecting condition
Value of pressure control solenoid valve output
current is too low for 12.5 seconds or more.
(1 driving cycle detection logic)
DTC Confirmation Procedure
1) Clear DTC.
2) Start engine and run it for 1 minute.
3) Check DTC.
DTC Troubleshooting
Step
1 Was "A/T System Check" performed?
2 Check pressure control solenoid valve resistance
1) Turn ignition switch to OFF position.
2) Disconnect valve body harness connector (1) on
transaxle.
3) Check for proper connection to "LT GRN" and "GRY"
terminals of valve body harness connector.
4) Check resistance of pressure control solenoid valve.
Resistance of pressure control solenoid valve
Between (3) and (4) terminals of valve body harness
connector: 3.3 – 3.7 Ω at 20 °C (68 °F)
Between (3) terminal of valve body harness
connector and vehicle body ground (2): Infinity
2
Is check results satisfactory?
3 Check pressure control solenoid valve circuit for
ground short
1) Connect valve body harness connector.
2) Disconnect TCM connectors.
3) Check for proper connection to TCM at terminals "C06-
2" and "C06-4".
4) If connections are OK, check continuity between
terminal "C06-4" of disconnected harness side TCM
connector and ground.
Is continuity indicated?
Action
4
3
1
• Pressure control solenoid valve or its circuit malfunction.
• TCM
Yes
Go to Step 2.
Go to Step 4.
I7RW01510013-01
"LT GRN/BLK" or "GRY"
circuit shorted to
ground.
Trouble area
No
Go to "A/T System
Check".
Replace pressure
control solenoid valve or
lead wire.
Go to Step 5.
S6RW0C5104029