Precautions For Discharge Headlight Service; Precautions In Diagnosing Troubles - Suzuki 2006 SX4 Service Manual

Lighting Systems
Body, Cab and Accessories
Precautions for Discharge Headlight Service (If Equipped)
WARNING
!
• Do not touch igniter or ballast when lighting switch is at "HEAD" position to avoid possible electric
shock.
• Do not measure voltage or resistance with tester connected to output connector of ballast or igniter
to avoid possible electric shock.
• Do not perform work where exposed to water including rain or with wet hands to avoid possible
electric shock.
• Disassembling igniter or ballast is strictly prohibited as it may cause an electric shock.
• Before inspecting or repairing discharge headlight or its peripheral parts, make sure that lighting
switch is at OFF position and battery is disconnected at negative terminal to avoid possible
electrical shock.
• Do not set lighting switch to "HEAD" position with connector disconnected or any part removed to
avoid possible electric shock.
• Do not touch glass surface of headlight bulb. Oil or grease attached on it may not only make bulb
service life shorter but also cause bulb to burst when lighting switch is turned on.
• Mercury, metal iodide and xenon gas are sealed in discharge headlight bulb. Be sure to dispose of
used discharge headlight bulb properly according to applicable rules or regulations.
Precautions in Diagnosing Troubles (Headlight Auto Leveling System)
• Be sure to read "Precautions for Electrical Circuit Service in Section 00" before inspection and observe what is
written there.
• Replacement of height sensor and headlight leveling control module. When height sensor and/or headlight leveling
control module is replaced with new one, perform initialization of headlight auto leveling system according to
"Initialization of Headlight Auto Leveling System".
Precautions
Lighting Systems: 9B-1
S6RW0C9200001
S6RW0C9200002