Suzuki 2006 SX4 Service Manual page 484

3B-46 Differential:
32) Apply grease to oil seal lip, and then install oil seals
(1) to rear differential (2) using special tool as shown
in figure.
NOTE
Install oil seal horizontally to surface of rear
differential case.
"A": Grease 99000–25010 (SUZUKI Super
Grease A)
Distance between rear differential and oil seal
"a"
: 1.0 – 2.0 mm (0.04 – 0.08 in.)
Special tool
(A): 09913–75810
(A)
Tightening Torque Specifications
Fastening part
Differential oil level / filler plug
Differential oil drain plug
Coupling air temperature sensor
Bevel gear bolt
Bevel pinion nut
Differential cover bolt
Flange nut
Coupling case bolt
NOTE
The specified tightening torque is also described in the following.
"Rear Differential Mountings Components"
"Rear Differential Components"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fasteners Information in Section 0A".
1, "A"
2
"a"
2
I5RW0A320063-02
Specifications
33) Install drive shaft flange.
34) Install rear mounting bracket to rear differential
referring to "Front Mounting Arm and/or Rear
Mounting Bracket Assembly Removal and
Installation".
Rear Differential Inspection
• Check companion flange for wear or damage.
• Check bearings for wear or discoloration.
• Check differential carrier for cracks.
• Check drive bevel pinion and bevel gear for wear or
cracks.
• Check side gears, pinion gears and pinion shaft for
wear or damage.
• Check side gear spline for wear or damage.
Tightening torque
N⋅m kgf-m
23 2.3
23 2.3
18 1.8
73 7.3
230 – 340 23.0 – 34.0 166.5 – 246.0
23 2.3
110 11.0
23 2.3
S6RW0C3206015
S6RW0C3207001
Note
lb-ft
17.0 /
17.0
13.0
52.0
17.0
79.5
17.0