Suzuki 2006 SX4 Service Manual page 719

4) Install one-way No. 3 clutch (1) to transaxle case.
NOTE
Make sure that groove section of one-way
No. 3 clutch faces (2) toward upper side.
5) Install snap ring (3), using flat end rod or the like.
NOTE
Make sure that opening end of snap ring
should be aligned with protrusion of
transaxle case.
3
6) Apply A/T fluid to new O-rings (1) and install O-rings
(1) to underdrive brake accumulator cover (2) and
underdrive brake accumulator piston (3).
7) Put underdrive brake accumulator spring (4) in
transaxle case, and insert under drive brake
accumulator piston (3) and underdrive brake
accumulator cover (2) into transaxle case.
NOTE
Do not twist or deviate O-rings during
installation.
2
1
3
1
4
2
1
I5RH01510024-01
I4RH01510198-01
Automatic Transmission/Transaxle:
8) Push underdrive brake accumulator cover and install
underdrive brake accumulator bracket (1), spacer (2)
and torsion spring (3) by tighten 2 torx
specified torque.
Tightening torque
Underdrive brake accumulator bracket bolt(s)
(a): 10 N·m (1.0 kgf-m, 7.5 lb-ft)
(a)
3
2
1
9) Apply A/T fluid to new O-rings (1) and install O-rings
(1) to underdrive brake piston assembly (2) and
underdrive brake piston cover (3).
10) Put underdrive brake piston return spring (4) in
transaxle case, and underdrive brake piston
assembly (2) and underdrive brake piston cover (3)
into transaxle case.
NOTE
Do not twist or deviate O-rings during
installation.
1
1
3
5A-131
®
bolts to
I4RH01510199-01
4
2
I4RH01510200-01