Suzuki 2006 SX4 Service Manual page 690

5A-102 Automatic Transmission/Transaxle:
5) Measure inside diameter of starter shaft bushing,
using special tools.
If inside diameter exceeds limit, replace starter shaft.
Starter shaft bushing inside diameter limit:
21.57 mm (0.849 in.)
Special tool
(A): 09900–20607
(B): 09900–22403
NOTE
Perform measurement at several points.
6) Check that sliding surface of friction, separator and
cushion plates are not worn or burnt.
If necessary, replace.
NOTE
• If friction plate lining is exfoliated,
discolored or worn hardly, replace all
friction plates.
• Before assembling new friction plates,
soak them in A/T fluid for at least two
hours.
(A)
(B)
I4RH01510113-01
I2RH01510195-01
7) Measure height of 2nd brake return spring and 2nd
coast brake return spring. If necessary, replace.
2nd brake return spring height
Standard: 25.17 mm (0.99 in.)
2nd coast brake return spring height
Standard: 14.47 mm (0.57 in.)
NOTE
Do not apply excessive force when
measuring spring height.
Perform measurement at several points.
I2RH01510196-01