Scan Tool Data - Suzuki 2006 SX4 Service Manual

5A-24 Automatic Transmission/Transaxle:
DTC No. Trouble area
Lost Communication With
U0100
ECM / PCM "A"

Scan Tool Data

As the data values given in the following table are standard values estimated on the basis of values obtained from the
normally operating vehicles by using a scan tool, use them as reference values. Even when the vehicle is in good
condition, there may be cases where the checked value does not fall within each specified data range. Therefore,
judgment as abnormal should not be made by checking with these data alone.
Also, condition in the following table that can be checked by the scan tool are those detected by TCM and output from
TCM as commands and there may be cases where the automatic transaxle or actuator is not operating (in the
condition) as indicated by the scan tool.
Scan tool data
Ignition switch ON and engine stop
Input shaft
At 60 km/h (37.5 mile/h) constant speed, 20% or less
revolution
throttle opening and 3rd gear ("3" range)
At vehicle stop
Output shaft
At 60 km/h (37.5 mile/h) constant speed, 20% or less
revolution
throttle opening and 3rd gear ("3" range)
Battery voltage Ignition switch ON and engine stop
ATF temperature Ignition switch ON and engine stop
Pressure control Sol At specified idle speed after warming up
Vehicle speed
Ignition switch ON and select lever is in "P" position
Ignition switch ON and select lever is in "R" position
Ignition switch ON and select lever is in "N" position
Gear position Ignition switch ON and select lever is in "D" position
Ignition switch ON and select lever is in "3" position
Ignition switch ON and select lever is in "2" position
Ignition switch ON and select lever is in "L" position
Ignition switch ON and select pedal released
Throttle position
Ignition switch ON and select pedal depressed fully
Accel actual Ignition switch ON and select pedal released
position Ignition switch ON and select pedal depressed fully
Engine speed At specified idle speed after warming up
Coolant
Ignition switch ON and engine stop
temperature
Ignition switch ON and cruise control switch OFF
Cruise control signal
Ignition switch ON and cruise control switch ON
Transaxle range Ignition switch ON and engine stop
Ignition switch ON and select lever to "3" or "2" range
"3" position switch Ignition switch ON and select lever to other than "3" or
"2" range
TCM is controlled as follows.
• Line pressure is controlled to maximum pressure.
• Lock-up function is inhibited.
• TCM assumes throttle position signal to be 100%.
• TCM assumes engine speed to be 0 RPM.
• After 15 minutes pass from detecting malfunction, TCM assumes
engine coolant temperature to be 90 °C (194 °F).
• Gear position is fixed according to select lever position as follows.
– D range: Fixed to 4th gear position
– 3 range: Fixed to 4th gear position
– 2 range: Fixed to 3rd gear position
– L range: Fixed to 1st gear position
Vehicle condition
—
Fail safe operation
Normal condition / reference
2300 RPM
(displayed in increments of 50 rpm)
2300 RPM
(displayed in increments of 50 rpm)
Battery voltage is displayed
A/T fluid temperature is displayed
Vehicle speed is displayed
0 – 12%
90 – 100%
0 – 12%
90 – 100%
Engine revolution speed is
displayed
Engine coolant temperature is
displayed
Select lever position is displayed
S6RW0C5104008
values
0 RPM
0 RPM
0%
P or N
R
P or N
1
1
1
1
OFF
ON
ON
OFF