Suzuki 2006 SX4 Service Manual page 724

5A-136 Automatic Transmission/Transaxle:
55) Apply A/T fluid to 4 new gaskets (1).
56) Install 4 new gaskets (1) to transaxle case.
57) Apply A/T fluid to transaxle lubrication tubes (2).
58) Install tube clamp (3) and tighten the torx
specified torque.
Tightening torque
®
Tube clamp torx bolt (a): 9 N·m (0.9 kgf-m, 6.5
lb-ft)
1
2
59) Apply petroleum jelly to input shaft rear thrust
bearing rear race (1).
60) Place input shaft rear thrust bearing rear race (1) to
transaxle rear cover (2).
1
61) Apply sealant to mating surface of transaxle case by
using a nozzle as shown in figure by such amount
that its section is 1.5 mm (0.059 in.) in diameter.
"A": Sealant 99000–31230 (SUZUKI Bond
No.1216B)
"A"
62) Install transaxle rear cover to transaxle case by a
tightening bolts to specified torque.
Bolt
®
bolt to
NOTE
Make sure to use new transaxle rear cover
bolts A, B and D.
Tightening torque
Transaxle rear cover bolts (a): 10 N·m (1.0 kgf-
m, 7.5 lb-ft)
Transaxle rear cover bolts (b): 24 N·m (2.4 kgf-
m, 17.5 lb-ft)
3
(a)
I4RH01510222-01
63) Apply A/T fluid to inner surface of new countershaft
front bearing (1).
64) Install new countershaft front bearing (1) to transaxle
housing, using special tool.
2
Special tool
(A): 09913–75510
I4RH01510223-01
I4RH01510224-01
Size Length (mm)
A M6
B M8
C M8
D M8
A, (a)
B, (b)
D, (b)
C, (b)
1
Pieces
16 2
25 2
45 4
48 3
B, (b)
A, (a)
D, (b)
I4RH01510225-01
A
I4RH01510226-01