Side Curtain-Air Bag (Inflator) Module Inspection; Forward Impact-Sensor Removal And Installation - Suzuki 2006 SX4 Service Manual

8B-103 Air Bag System:
3) Connect side curtain-air bag (inflator) module
connector (1) securely as shown in figure.
a) Connect connector.
b) Lock connector with lock button (2).
b)
a)
1
4) Install head lining referring to "Head Lining Removal
and Installation in Section 9H".
5) Enable air bag system. Refer to "Enabling Air Bag
System".
Side Curtain-Air Bag (Inflator) Module
Inspection
WARNING
!
• Never measure resistance of side curtain-
air bag (inflator) module or disassemble it.
Otherwise personal injury may result.
• Never attempt to disassemble or repair the
side curtain-air bag (inflator) module. If any
abnormality is found, be sure to replace it
with new one as an assembly.
• Be sure to read "Precautions on Service
and Diagnosis of Air Bag System",
"Precautions on Handling and Storage of
Air Bag System Components" and
"Precautions on Disposal of Air Bag and
Seat Belt Pretensioner" before starting to
work and observe every precaution during
work. Neglecting them may result in
personal injury or undeployment of the air
bag when necessary.
2
I5RW0A820078-01
S6RW0C8206023
CAUTION
!
If air bag (inflator) module was dropped from
a height of 90 cm (3 ft) or more, it should be
replaced.
Check air bag (inflator) module appearance visually for
the following symptoms and if any one of them is found,
replace with a new one.
• Air bag has deployed.
• Inflator case being damaged or having been exposed
to strong impact (dropped).
Forward Impact-Sensor Removal and
Installation
WARNING
!
During service procedures, be very careful
when handling a sensor.
• Never strike or jar a sensor.
• A sensor and mounting bracket bolts must
be carefully torqued to assure proper
operation. Under loose connection, it
could cause improper operation of the air
bag system.
Removal
1) Disconnect negative (–) cable at battery.
2) Disable air bag system referring to "Disabling Air
Bag System".
3) Remove front bumper referring to "Front Bumper
and Rear Bumper Components in Section 9K".
4) Disconnect forward impact-sensor connector (1)
sliding connector outer (2) as shown.
I5JB0A820089-02
S6RW0C8206013