Suzuki 2006 SX4 Service Manual page 297

Fastening part
Timing chain cover bolt and nut
Idler pulley nut
Generator belt tensioner bolt
Crankshaft pulley bolt
Camshaft timing sprocket bolt
Timing chain tensioner adjuster No.2 bolt
Timing chain tensioner adjuster No.2 nut
Timing chain tensioner nut
Timing chain tensioner adjuster No.1 bolt
Timing chain guide No.1 bolt
Camshaft housing bolt
Cylinder head bolt (M10)
Cylinder head bolt (M6)
Connecting rod bolt
Crankcase bolt with 10 mm thread diameter ((1)
– (10))
Crankcase bolt with 8 mm thread diameter ((11)
– (22))
CKP sensor bolt
Flywheel or drive plate bolt
Engine front mounting bracket bolt
NOTE
The specified tightening torque is also described in the following.
"Air Cleaner Components"
"Electric Throttle Body and Intake Manifold Components"
"Cylinder Head Cover Components"
"Engine Mountings Components"
"Timing Chain Cover Components"
"2nd Timing Chain and Chain Tensioner Components"
"1st Timing Chain and Chain Tensioner Components"
"Camshafts, Tappet and Shim Components"
"Valves and Cylinder Head Components"
"Pistons, Piston Rings, Connecting Rods and Cylinders Components"
"Main Bearings, Crankshaft and Cylinder Block Components"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fasteners Information in Section 0A".
Tightening torque
N⋅m kgf-m
11 1.1
42 4.2
25 2.5
150 15.0
80 8.0
11 1.1
45 4.5
25 2.5
11 1.1
9 0.9
Tighten 11 N⋅m (1.1 kgf-m, 8.0 lb-ft) by the
specified procedure
Tighten 52 N⋅m (5.2 kgf-m, 38.0 lb-ft), 82
N⋅m (8.2 kgf-m, 59.5 lb-ft), 0 N⋅m (0 kgf-m,
0 lb-ft), 52 N⋅m (5.2 kgf-m, 38.0 lb-ft) and
103 N⋅m (10.3 kgf-m, 74.5 lb-ft) by the
specified procedure
11 1.1
Tighten 15 N⋅m (1.5 kgf-m, 11.0 lb-ft), 45°
and 45° by the specified procedure
Tighten 40 N⋅m (4.0 kgf-m, 29.0 lb-ft), 0
N⋅m (0 kgf-m, 0 lb-ft), 40 N⋅m (4.0 kgf-m,
29.0 lb-ft), 58 N⋅m (5.8 kgf-m, 42.0 lb-ft) by
the specified procedure
Tighten 26 N⋅m (2.6 kgf-m, 19.0 lb-ft) by the
specified procedure
11 1.1
70 7.0
55 5.5
Engine Mechanical:
Note
lb-ft
8.0
30.5
18.5
108.5
57.5
8.0
33.0
18.0
8.0
6.5
/
8.0
/
8.0
51.0
40.0
1D-66