Suzuki 2006 SX4 Service Manual page 721

20) Apply petroleum jelly to underdrive clutch thrust
bearing (1) and countershaft rear thrust bearing race
(2).
21) Install underdrive clutch thrust bearing (1) and
countershaft rear thrust bearing race (2) to
underdrive clutch assembly (3).
22) Install underdrive clutch assembly (3) onto transaxle
case.
3
23) Make sure that underdrive clutch turns freely when
turned counterclockwise [A] and locks when turned
clockwise [B].
[A]
24) Apply petroleum jelly to countershaft rear thrust
bearing (1), countershaft front thrust bearing (2) and
countershaft front thrust bearing race (3).
25) Install countershaft rear thrust bearing (1),
countershaft front thrust bearing race (3) and
countershaft front thrust bearing (2) to counter driven
gear.
26) Install underdrive gear assembly (4) onto under drive
clutch (5).
4
5
2
1
I4RH01510206-01
[B]
I4RH01510207-01
2
3
1
I4RH01510208-01
Automatic Transmission/Transaxle:
27) Install parking lock pawl (1). Place torsion spring (2)
on parking lock pawl shaft (3) and install them into
transaxle case.
28) Install parking lock pawl bracket and manual detent
spring (4) by 2 tightening bolts to specified torque.
Tightening torque
Manual detent spring bolt No.1 (a): 10 N·m (1.0
kgf-m, 7.5 lb-ft)
Manual detent spring bolt No.2 (b): 5.5 N·m (0.55
kgf-m, 4.0 lb-ft)
3
2
29) Insert parking lock rod (1) to parking lock pawl
bracket and connect parking lock rod (1) with manual
shift shaft (2).
30) Install reduction drive gear assembly (1) into
transaxle case (2).
31) Install snap ring (3).
1
3
5A-133
(a) (b)
4
1
I7RW01510057-01
1
2
I4RH01510210-01
2
I4RH01510211-01